US Navy Cutlass M1860

US Navy Cutlass M1860

Please note: This is just an ornamental item, not intended for real use!

• Total length approx. 800mm
• Blade length approx. 650mm
• Length of the grip (distance between guard and pommel) approx. 110mm
• Blade width at the guard approx. 31.1mm
• Thickness of the blade at the guard approx. 4.5mm
• The fuller is 435mm long and approx. 18mm wide
• Blade width 10cm off the blade point approx. 25.2mm
• Thickness of the blade 10cm off the blade point approx. 3.7mm
• There are etched codes on the blade . From one side USN DR 1862 from the other AME SM FGCO CHICOPE MASS
• Length of ricasso approx. 60mm; Here is the blade is approx. 3.7mm thick
• CoB (Center of Balance) approx. 10cm from the handle
• Thickness of the cutting edge approx. 1.0mm
• The finger guard consists of approximately 0.6mm thick brass sheet. It is riveted to a cast brass loop and guard (in one piece)
• The handle is wrapped with black leather and toughened with a twisted brass wire.
• Weight without sheath approx. 868 g
• Total weight incl. sheath approx. 1202 g

Even if this is a fully functional cutlass, it cannot be used in combat shows, historical reenactment or similar for safety reasons!

Specs may slightly vary from exemplar to exemplar.

Premium Quality, made by Windlass Steelcrafts®.